Vancouver Overhead Door
Installing the sections of a new garage door

Garage Door Replacement and Installation, Coquitlam

From mid-century houses in Maillardville to hillside homes on Westwood Plateau and new builds on Burke Mountain, we fit new garage doors that suit the house and the slope it sits on.

  • Sloped hillside garage floors need the new door set to seal evenly along the bottom.
  • Plenty of 1990s Westwood Plateau homes still run original springs and openers, so we check both at the quote.
  • Burke Mountain townhouses usually need strata approval before the door changes.
The short answer

Garage door installation in Coquitlam starts with a site visit. We measure the opening, check how level the garage floor is, look at your opener and give a quote before anything is booked. The install itself usually takes one visit of about half a day: the old door, springs and tracks are removed and hauled off, the new door is hung and balanced, and the opener is reconnected or replaced. We work across Westwood Plateau, Burke Mountain, Austin Heights, Maillardville and Eagle Ridge.

  • Higher neighbourhoods get colder mornings and some snow, which favours an insulated door on attached garages.

Hillside garages on Westwood Plateau and Burke Mountain

A lot of Coquitlam is built on slopes. On Westwood Plateau, Burke Mountain and parts of Eagle Ridge, the garage floor often runs downhill toward the street or tilts side to side. An old door on a floor like that leaves a gap at one corner, lets in rain and cold air, and tends to come off track.

When we replace a door on a sloped floor, we set the track and bottom seal so the new door closes flat against the concrete along its full width. That is one reason we measure on site instead of quoting from a photo.

These neighbourhoods also sit well above sea level. They get more rain, cooler nights and the odd snowfall, and many lots back onto forest or ravines. A door that seals properly matters more up there than in the flatter parts of the city.

Rotting bottom panel of an old wood garage door
Rotting bottom panel of an old wood garage door

Signs it's time for a new door rather than a repair

We repair doors too, and we say so when a repair is the smarter spend. Replacement usually makes sense when:

  • an old wood door is rotting, warped or sagging, common on the older homes in Maillardville and Austin Heights
  • a steel door is dented past what a panel swap can fix
  • replacement panels for your model aren't made any more
  • the garage stays cold or drafty because the door has no insulation
  • repairs keep coming on a worn-out door
  • you want a quieter door before turning the garage into a workspace
  • the door makes the front of the house look dated

On 1990s Westwood Plateau homes, the springs and opener are often original too. We look at the whole set-up and tell you plainly what should change.

Opener, insulation and strata questions

Your opener can often stay if it is in good condition and suited to the new door's weight. Many openers on 1990s homes here are near the end of their life, though, and swapping it on the same visit saves a second trip.

For an attached garage, or one under a bedroom, an insulated door keeps the room warmer and quieter through Coquitlam's cold mornings on the hills. A detached garage used only for storage can often take an uninsulated door.

If you own a townhouse on Burke Mountain or in a complex near Coquitlam Centre, the strata usually controls exterior changes, including door style and colour. Get approval first and we will quote a door that meets the rules.

Price depends on size, style, insulation, windows, hardware and whether the opener stays. You get the number on site before any work is booked.

What we see in Coquitlam

  • Westwood Plateau and Burke Mountain sit higher up, with colder mornings, more rain and occasional snow.
  • Many 1990s homes on Westwood Plateau still have their original springs and openers.
  • New Burke Mountain townhouses are usually under strata rules that control exterior changes.
  • Hillside garages with sloped floors need careful setup so the new door seals evenly.
  • Maillardville and Austin Heights have many mid-century homes with older doors.
  • Burke Mountain
  • Westwood Plateau
  • Coquitlam Centre
  • Maillardville
  • Austin Heights
  • Ranch Park
  • Eagle Ridge
  • Harbour Chines
FAQ

Questions homeowners ask

My garage floor slopes. Can a new door still seal properly?

Yes. We measure the slope at the quote and set the track and bottom seal so the door closes evenly across the floor. Sloped floors are common on Westwood Plateau and Burke Mountain.

How do I know whether to repair or replace?

A sound door with parts still in production is usually worth repairing. Rot, repeated panel damage, parts that are no longer made, or no insulation are the main reasons to go with a new door.

Does the old door get removed?

Yes. We take down the old door, springs and tracks and haul them away as part of the job.

Will my 1990s opener work with the new door?

Sometimes. If it is in good shape and suits the new door's weight, we reconnect it. If it is worn, we say so at the quote and you can decide whether to replace it at the same time.

Do Burke Mountain townhouses need strata approval?

In most complexes, yes. The strata usually sets door style and colour. Get the approval first and we will quote to match.

How long is the install?

Most single and double doors are done in one visit of about half a day.

Should a Westwood Plateau garage have an insulated door?

If it is attached or sits under living space, an insulated door helps with the colder mornings at that elevation and keeps the garage quieter. For detached storage, uninsulated is often fine.

Service area

Nearby areas

Get a new door quoted in Coquitlam

Call or send the form to book a measure. We check the floor, the opener and the opening, and quote before work is booked. We also serve Port Coquitlam, Port Moody, Pitt Meadows and Surrey.

CallBook service